Snowboard Rack For Wall Ideas

Home » Home Ideas » Snowboard Rack for Wall Ideas

Snowboard rack – A roof rack is a good investment for all snowboarders. Transporting snowboards in the interior of the car can cause scratching or water damage from melting snow. Moreover boarding equipment takes place that would otherwise be filled by your snowboard buddies. If you have rails on your car, you can easily get your car, friends and snowboards the entire mountain safely with the help of a snowboard roof rack. Store your snowboards where they are easily accessible and visible by building your own snowboard carrier. The simple tube design of the rack can you line a wall with brackets, leaving the rack virtually invisible while highlighting the boards themselves. With the majority of the parts readily available in pre-cut lengths, the mounting of each rack level quickly made. You will be able to complete a multi-layer rack in under an hour, using cheap building materials that cost a fraction of the price of retail racks.

Posted on October 3, 2017 Home Ideas

Build a snowboard rack for wall ideas, locate the studs in the wall where you want to build snowboard carrier. Run a stud finder across the wall and listen to the indicator beeps or watch the indicator light on finders display to show a Studs s presence. Mark the location for two of the studs, either 16 or 24 inches apart, depending on the distance between the studs in the wall with a pencil. Place a carpenter’s level on the wall at the desired height of the snowboard rack, overlapping the two studs. Draw a horizontal alone along the ruler at the level that you want your holder placed.

13 Photos Gallery of: Snowboard Rack for Wall Ideas

Snowboard Rack DiySize: 2100 x 1750

Snowboard Wall RackSize: 1024 x 768

RELATED TOPIC :   Trayed Ceiling Decor Ideas

Build a snowboard rack for wall ideas; attach two 1-inch diameter pipe flanges at each end of the drawn line, centered on the line. Screw flanges through the wall and into the studs or screws by means of a drill bit with a screw attached. Screw 12-inch long, one-inch diameter tubes in each of the attached pipe flanges. The tubes will extend from the wall, parallel to the floor.

Measure and cut a 12-inch section of 1-inch diameter pipe insulation cork. Roll insulation during each of the tubes to provide a non-slip surface to place your boards. Screw pipe caps over the pipe ends to complete a rack level. Repeat the level creation process for as many rack levels that you want to create. Place each additional level of about 8 inches from the adjacent one in a line running along the two studs. Use the rack by sliding a snowboard rack on the two pipes.