How To Paint Plaster Ceiling Medallions
How To Paint Plaster Ceiling Medallions – Painting plaster and wood medallions only once decorated the roofs of palaces, government buildings, and homes and businesses in the rich. Also faux, prefabricated medallions of lightweight plastic has made it possible for anyone to inexpensively recover these magnificent roof interiors, they often lack the complex patterns or enrichment and embellishments. With preparation, concentration and a few items from a local home improvement stores, you can easily make an elaborate ceiling medallion for your home. For treatment of Roofs should always be painted before any other surface are painted in the room, including the walls and trim.
Instructions to paint plaster ceiling medallions, Repair cracks in the ceiling before painting. Remove all dust and cobwebs with a vacuum cleaner and wet rags. Fill any holes or gaps with sealant. Select a high-quality latex paint. Look for a 100 percent acrylic paint. Not all acrylics are full acrylic, and some may contain other additives and chemicals that cannot follow a plaster ceiling. To be considered as 100 percent acrylic, the label can be particular as printed on it. Trademarks Behr Home Depot and Lowes Valspar is full acrylic paints.
12 Photos Gallery of: How To Paint Plaster Ceiling Medallions
Tape the edges of plaster ceiling medallions with masking tape (often colored blue). Polish the edges and make sure there are no gaps that paint can seep. Wood trim and light fixtures may also need to be taped. Prime the ceiling with an alkaline-resistant primer. The primer can be latex paint to adhere to the plaster ceiling. The primer prevents alkaline plaster seeps through the layer of color. If not sealed properly, the paint can peel and fade. Priming and painting will follow the same technique.
Next steps to paint plaster ceiling medallions cut the perimeter of the roof and work around the edges. Dip an angled brush something in the paint. Glide brush along the edge of the roof, with the tip of the brush to make a straight line. The brush will fan out, so that the tip to form a straight line. This technique is referred to by painters as “cutting in.” Leave 1:03 – to 4-inch whole band of color. Use a 3-inch synthetic brush that has an angle and is made for trim work. If the plaster is highly structured, it may be necessary to throw him into a second brush to get all the grooves and recesses of plaster painted. A second or even third coat may be necessary, depending on the color. Roll the paint in sections, using a roller with the appropriate nap. If the plaster has a very rough texture, recommended a 3/4-inch nap roller. Use a 1/2-inch nap roller for smooth plaster walls. Attach the roller pole painting for further ease and control of the area color. Roll in long strokes, also exerting pressure. Apply a second coat if needed. Remove all tape. Pull the tape off slowly. If there is resistance, use a razor knife easily cut the ribbon. Carefully remove all of the drop cloths and plastic color can easily drop from the plaster ceilings and remain wet on the protective sheet.