Add Finish To Red Oak Stair Treads

Home » Home Decor » Add Finish to Red Oak Stair Treads

Red oak stair treads – Red oak is desirable in applications where you can enjoy its surface structure. Used in the construction of cabinets, hardwood floors and trim work is the red oak is also an acceptable wood for stairs. The wood has a pink or gold tone and you can use a stain, or let the natural color of the wood dominates. Since you finishing steps, you need a durable topcoat to withstand foot traffic.

Posted on November 9, 2017 Home Decor

Fill the nail holes with wood filler. If staining steps, use wood putty that matches your glaze. Use a 150-grit sanding block to smooth the surface of the unfinished red oak treads. Sand the edges and under the front lip and side lips as well. Sand only in the direction of the wood fibers. Apply masking tape on red oak stair treads risers, over and under the stairs. You will also need tape around the wall and off the stair trim to protect them. Wipe off the steps, tribes and adjoining walls with tack cloth to create a dust-free zone for dyeing and finishing.

12 Photos Gallery of: Add Finish to Red Oak Stair Treads

Applying beet, if desired, by brushing it with a brush, or by smoothing it on with a stain applicator pad. If you use a pad, you will still need a brush to make the outsides of the tread and lower lip. Allow the stain left on the steps until the wood absorbs the desired amount of color, and then wipe the red oak stair treads firmly on absorbent soft rags, and let them dry completely. Apply a thin layer of wood finish with a quality brush. Acceptable finishes for treads include polyurethane, lacquer and varnish. Brush the solution on the direction of the wood grain and let it dry.

RELATED TOPIC :   Pegasus Bathroom Faucet - Start The freshness of the With A New Spirit

Sand only the surface of the red oak stair treads steps, after the finish coat dries, with 220-grit sanding block. Use very light pressure. This is micro sandpaper and it will not remove the gloss on the surface of the steps, but it will knock out any dust particles that fell and stuck on the wet finish. Apply one or more additional surface coats, brush them in the same way and let the treads dry completely between coats. Tips, if you like the natural color of red oak, you can skip the stain and apply only topcoat. Dry wipes that are wet with stain outdoors in a single layer on the ground. Throw them in outdoor waste containers. If wet stain rags are stuck in a bin, they can flare up.